self-contained units of composition preparation

1. The purpose of the product AUPS is designed for preparation of drilling fluids and formulations. Possible ways of preparing solutions and compositions water-based with the use of salts of different density, chemical reagents, fluids, formulations based on hydrocarbons (gas condensate stable up to 80%, oil, diesel fuel, gasoline) 2. Scope treatment of bottom-hole zones of oil and gas wells, operations aimed at increasing oil recovery, the possibility of preparing formulations for killing and carrying out technological operations in workover and repair operations. 3. Climatic version operation in climatic regions with moderate cold climate to GOST 16350-80, climatic design cold temperate climate-1 according to GOST 15150-96 (-45...+45C). 4. Advantages application in AUPS of jetting fuel injection type, together with mechanical peremeshivaya eliminates settling and caking of heavy particles not only on the bottom of the tank, but in the corners, that allows to provide a high level of mixing and to reduce the time of preparing solutions and compositions the composition of the AUPS included a water filtration system that delivers on the fence filtration of prepared solutions and formulations to 5 microns and does not require additional stages of filtration the possibility of using electrical equipment in explosion-proof execution allows to use AUPS near the mouth of wells less than 25m, when completing the AUPS external control Cabinet with electrical equipment in industrial design in conjunction with the cable of more than 30m, will also allow you to use the installation near the mouth of wells less than 25m, but it significantly reduces the cost of a single installation AUPS may be used in the composition of the circulating system of a drilling rig or a stand-alone, The location of all nodes AUPS separate blocks in a single frame provides a high level of industrial safety, reliability and Assembly-suitability. With this setting is convenient in the transportation to the place of production of the robot and the service.